This is a simple breakout board for the BMP085 high-precision, low-power barometric pressure sensor.
The BMP085 offers a measuring range of 300 to 1100 hPa with an absolute accuracy of down to 0.03 hPa. It's based on piezo-resistive technology for EMC robustness, high accuracy and linearity as well as long term stability. This sensor supports a voltage supply between 1.8 and 3.6VDC. It is designed to be connected directly to a micro-controller via the I²C bus
This board breaks out all pins of the BMP085 to a 4-pin 0.1" pitch header and also features put two 10k pull-up resistors on the I2C lines.Learn More
The digital color light sensor are designed to accurately derive the color chromaticity and illuminance (intensity) of ambient light and provide a digital output with 16-bits of resolution.Learn More
₨1,790.00The Memsic 2020 is a low cost, dual-axis thermal accelerometer capable of measuring tilt, acceleration, rotation, and vibration with a range of ±1 g. For integration into existing applications, the Memsic 2020 is electrically compatible with other popular accelerometers. Learn More
HMC5883L is a 3-axis digital compass from Honeywell. Communication with the HMC5883L is simple and all done through an I2C interface. There is no on-board regulator, so a regulated voltage of 2.16-3.6VDC should be supplied.
This breadboard-friendly board breaks out pins to a 4-pin 0.1" pitch header and it also has two 10k pull-up resistors on the I2C lines.Learn More
₨50.00A pair of low-force omnidirectional tactile sensors which are used for obstacle avoidance in Photovore Kit. Learn More
Regular Price: ₨330.00
Special Price: ₨300.00
The TSOP-OBSD–Dual is a general purpose proximity sensor. Here we use it for collision detection. The module consist of two IR emitter and TSOP receiver pairs. One for obstacles on left, and the other for right. The high precision TSOP receiver detects a signal of fixed frequency.Learn More
₨560.00This is a small force sensitive resistor. It has a 0.16" (4 mm) diameter active sensing area. This FSR will vary its resistance depending on how much pressure is being applied to the sensing area. The harder the force, the lower the resistance. When no pressure is being applied to the FSR, its resistance will be larger than 1MΩ, with full pressure applied the resistance will be 2.5kΩ. Learn More
Out of stock
This is a high gain GPS Receiver (5V Serial) with 4pin 2.54mm pitch Berg strip. Receiver is made with third generation POT (Patch Antenna On Top) GPS module. The built in 3V3 to 5V level convertor enable us to interface with normal 5V Microcontrollers. Its low pin count (4Pin) will make it easy to interface and it is bread board friendly (2.54mm connector).Learn More